Home << Product Main << Night Vision Cam Main

 

 Installation Guide of Night Vision Manual Adjustable Varifocal Camera

 

 

 Click pictures to view the enlarged version...


click to enlarge...

1. Choose your camera location and install the included, separately purchased, your own camera mount firmly.


click to enlarge...

2. Attach the camera on the camera mount installed just screwing in to the universal joint screw that affixed on the camera mount.


click to enlarge...

3. Layout the cable laying it behind ceiling or around corners of the room to the camera location from recording device or outcome display monitor and connect it with the video, power, and audio cable (if available) of the camera.


click to enlarge...

4. Hide unwanted portion of the cable behind ceiling for clean professional appearance.


click to enlarge...

5Connect the other end of the cable as Yellow to Video-in & White to Audio-in (if available) on the back of the recording device or outcome display monitor (if connecting directly to the monitor), then Red to the included 12V power transformer or your own 12V power source.


6. Connect the other end of the cable to the outcome display monitor either directly from the camera or recording device (if the camera is connected via) as the connection procedure explained on 5 and power up all equipments that connected the system.


click to enlarge...click to enlarge...

7. Go to the camera location and unscrew the camera housing to open up. Then remove the form ring that worn around the zoom lens.


click to enlarge...click to enlarge...

8. Unscrew the knob labeled &<--->N to adjust zoom length and unscrew the knob labeled T<--->W to focus, then screw knobs back to fix the lens firmly and also screw back the camera housing. Next step, adjust viewing angle of the camera looking at the connected monitor and tighten back the joint knob turning it clockwise firmly when the camera-viewing angle is adjusted as desired.


click to play...

9. IR light cannot be seen by human eyes and only possible to be seen through the connected display monitor. Thus, make sure to adjust a night viewing angle in the dark and so the IR vision can be seen through the monitor. Objects exposed to the IR light that are too close to the camera will produce a white glow reflection, so pay attention to put objects at least 10ft away from the camera.


10. When the monitor location is out of viewable range from the camera, one more person to be needed to assist on correcting the camera-viewing angle while the other person is adjusting the actual camera angle at the camera location. 

*Infrared light cannot be seen by human eyes and only possible to be seen through the connected display monitor.


click to enlarge...click to enlarge...

11. Make sure to tighten up all screwed portions of the camera housing all the way and suggested to seal them with any conventional waterproof plumbing sealant when the camera is installed outdoor and especially exposed to harsh environments. 

*Also make sure to put on the included rain & sunshield (if available) when the camera is installed outdoor.


click to enlarge...

12. At last, make sure to wrap around all cable connections securely with the electrical tape when it is intended to leave outdoor for long time.


 PAGE TOP

Home | About Us | Contact Us | Tech-Support | Product | Directory